Times are displayed in (UTC+02:00) Amsterdam, Berlin, Bern, Rome, Stockholm, Vienna Change
Tuesday, June 16, 12:00 PM - 1:30 PM
Poster Session
Session Chairs:
Thiyagarajan Janakiraman,
Marco Castaldi,
Presentations
Note: Presentations may start a few minutes before the time listed in the schedule.
| Participant Role | Details | Action |
|---|---|---|
| Submission | Reduced-Order Kinetic Calculations of Water-Diluted Hydrogen Combustion at Aeroengine Conditions | View |
| Submission | Geometric Effects of Hole Angles on the Similarity of Film Cooling Effectiveness Under Thermal Variations | View |
| Submission | Experimentally Calibrated Porous-Media Modeling of Brush Seals for Coupled Leakage and Frictional Heating Prediction | View |
| Submission | Impact of Low-Carbon Fuels on Flame Dynamics in a Gas-Turbine Relevant Combustion Systems | View |
| Submission | Gpu-Accelerated Density-Based Flamelet Combustion Solver for Compressible Reacting Flows | View |
| Submission | Numerical Study and Data-Driven Modeling of Flat-Plate Transpiration Cooling | View |
| Submission | Case Study on Small-Scale Supercritical Co2 Axial-Flow Turbine | View |
| Submission | Novel Method for Optimizing Tco₂ Centrifugal Pump Blade Profiles: An Inverse Problem Framework Driven by Forward Problem Geometric Features | View |
| Submission | Centrifugal Compressor Design for Mechanical Vapor Recompression (Mvr) | View |
| Submission | Reproducibility and Human Error in Hardness Measurements: A Comparative Study of Independent User Data | View |
| Submission | How Semi-Empirical Methods Stack-Up Against Surrogate Models - the Case of Nox Prediction | View |
| Submission | Torsional Vibration Damping Using a Modular Control Scheme With Preview | View |
| Submission | Impact of Inlet Swirl on an Aft Centrifugal Compressor Stage Design for an Axial-Centrifugal Compressor in Aero Engines | View |
| Submission | Cost-Efficiency Trade-Off in Allam Cycle Recuperator Performance: A Practical Assessment of Effectiveness. | View |
| Submission | Multispecies Measurements and Chemical Kinetic Modeling of Ammonia–natural Gas Fuel Blends at Gas Turbine Operating Conditions | View |
| Submission | A General Framework for Enhancing Film Cooling Predictions via Data Assimilation and Turbulence Model Correction | View |
| Submission | Experimental Study by Advanced Optical Diagnostics of a High-Pressure Rich Burn – Quick Mix – Lean Burn Lab-Scale Combustion Chamber | View |
| Submission | Numerical Study of Film Cooling Performance and Flow Structures With Surface Roughness | View |
| Submission | Numerical Study on the Influence of Swirl Intensity on the Effusion Cooling Characteristics Under Lean-Premixed Swirl-Stabilized Flame | View |
| Submission | Experimental Investigation of a Fuel-Staged Jet-Stabilized Burner Operating With 100% Hydrogen | View |
| Submission | Experimental Investigation on the Influence of Surface Roughness on Thin Shear-Driven Water Films | View |
| Submission | A Hierarchy of Computational Methods for Aerodynamic Analysis and Optimization of Aeronautical Propellers | View |
| Submission | Design and Creation of a High-Pressure Ammonia Boiling Rig | View |
| Submission | Extrapolation Capabilities of Neural Networks and Symbolic Regression Methods for Combustion Les | View |
| Submission | System-Level Performance of an Integrated Ammonia-Fueled Engine | View |
| Submission | Impact of Thermodynamic Property Modeling on Aero-Engine Mean-Line Design | View |
| Submission | Influence of Dynamic Modeling on Start-Up Simulation of Industrial Gas Turbines | View |
| Submission | Thermal Management System Optimization and Safety Assessment Analysis for Hydrogen Propulsion Systems | View |
| Submission | Thermodynamic Analysis of the Operating Cycle of the Trs‑18 Micro Jet Engine Powered by Conventional Fuel With the Addition of Hydrogen | View |
| Submission | Comparative Assessment of Co2 Compression Systems for Decarbonized Fossil Fuel Power Plants | View |
| Submission | Optimization of Honeycomb Seal Clearance Ratios for High-Pressure/temperature Supercritical Carbon Dioxide Within Labyrinth Seals | View |
| Submission | Nusselt Correlations for Microchannel Molten Salt Co2 Stairstep Heat Exchangers in Real Gas Conditions | View |
| Submission | High-Pressure Speciation and Chemical Kinetic Modeling of Dme-Propane Blends at High Pressure Turbine Conditions | View |
| Submission | Prediction of Combustion Instability in Hydrogen–methane Gas Turbine Combustors Using Flamelet-Based Framework and One-Dimensional Network Model | View |
| Submission | A Model-Derived Control Strategy for Hydrogen Co-Firing Gas Turbines Under Transient Co-Firing Ratio Variations | View |
| Submission | Study on Acoustic Mode Prediction Based on Non-Uniform Distribution of Flame Transfer Function in a Multi-Nozzle Combustor | View |
| Submission | Combined Thermodynamic and Weight Optimization of Advanced Gas Turbine Designs Under Multi-Point On- and Off-Design Operating Constraints | View |
| Submission | Effect of Hydrogen Enrichment on Flame Structure and Thermoacoustic Instability in a Single Nozzle Combustor | View |
| Submission | Dynamic Mechanism of Energy Loss in Centrifugal Pumps Under Off-Design Conditions | View |
| Submission | Performance Comparison of Cryogenic Floating Ring Seals and Annular Seals | View |
| Submission | Coupled Cfd–bem and Structural Load Analysis for Optimal Integration of Active Fluid Gurney Flaps in Wind Energy Systems | View |
| Submission | Nox Conversion Performance of a Medium-Temperature Scr for Ch4/h2/nh3 Gas Turbines | View |
| Submission | Study of an Ammonia Cracker for a Carbon-Free Turbofan | View |
| Submission | Reduction Methodology for Bladed Disk With Transient Cyclically Asymmetric Forcing Cases | View |
| Submission | Experimental Measurement and Prediction of Cryogenic Hydrostatic Thrust Bearing Performance Under High-Speed Rotation | View |
| Submission | Rapid Prototyping of a Constant-Velocity Acrylic Test Section for High-Subsonic Wet Wind Tunnels | View |
| Submission | Methodology for Replicating Rotating Detonation Combustor Outflow Conditions in a Linear Subsonic Turbine Cascade | View |
| Submission | Expected Designs for Hp Steam and Supercritical Co2 Turbines Across Different Applications | View |
| Submission | Cooling Characteristics of Combined Slot and Full Coverage Film Cooling on a Combustor Liner | View |
| Submission | Heat Transfer Characteristics of Additively Manufactured Pin-Fins With Flow-Guiding Structures for Enhanced Turbine Vane Trailing-Edge Cooling | View |
| Submission | Vki Ls89 Vane Leading Edge Film Cooling Using Sweeping Jet | View |
| Submission | Performance Modelling of a Hydrogen-Fuelled Aircraft Auxiliary Power Unit | View |
| Submission | Evaluating Blade Platform Overall Effectiveness in a High-Speed Research Turbine With Engine-Representative Cooling Flows | View |
| Submission | Determination of Pressure From Velocimetry Data for Incompressible and Compressible Flows | View |
| Submission | Evaluating the Metallurgical Effects of Rejuvenation Repair of Service Run Single Crystal Turbine Blades | View |
| Submission | Study of Exhaust Gas Recirculation and Humidification Mitigating Effects on Adverse Effects of Hydrogen Combustion in a Micro Gas Turbine | View |
| Submission | Measurements of Static Load Characteristics of Floating Sleeve Hybrid Journal Bearings Under High-Speed Rotation | View |
| Submission | Performance Measurements of a Hybrid Taper-Land Thrust Bearing in Air, Water, and Liquid Nitrogen | View |
| Submission | Towards Full-Surface Thermal Mapping With Imaging-Based Thermal History Coatings | View |
| Submission | Analysis of High Temperature Heat Pipes for Integration in High-Tit Sco2 Power Cycles for Advanced Nuclear Systems | View |
| Submission | The Influence of Jet-a to Hefa-Spk Fuel Switching on Young’s Modulus, Dimensional Change, and Degradation Behavior in Fluorocarbon Elastomer O-Rings | View |
| Submission | Dynamic Modelling and Control of a Supercritical Co2 Power Cycle for Waste Heat Recovery | View |
| Submission | Design, Build, Ignite: Lessons Learned From a Student-Led, Hands-on Turbomachinery Project | View |
| Submission | Experimental Identification of Dynamic Force Coefficients in Compliant Foil Bearings Lubricated With Liquid Nitrogen | View |
| Submission | Infrared Thermography Evaluation of Overall Cooling Effectiveness and Uniformity for an Industrial Gas Turbine Blade With Baseline and Modified Geometries | View |
| Submission | Design and Validation of an Emissions Analyzer for an Ammonia-Fueled Aircraft Engine | View |